S3 wireless kinetic switch specification
1> Product introduction
S3 wireless kinetic switch comes with push buttons, built-in energy acquisition module. It converts mechanical energy into electrical energy, driving Bluetooth chips to work. The Switch works with Ebelong controller, wireless controls the lamps on/off and dimming. It can be used in different Scenes to function too.
2. function and features
1> Pair with Ebelong wireless receiving controller
A. General pairing:
S3 series of switches function with wireless receiving controller, the pairing method is: long press on “pairing” button of receiver for three seconds, when indicator flashes slowly, press any buttons from S3 to get both units paired (Be sure not to press too much shorlty). Indicator goes off that means pair succeeds. Now S3 can be used to control receiver (for the function of receiver, please refer to the manual related to the wireless receiving controller)
If the controller is dimmable, when dimming mode is turned on, long-press the switch to adjust the brightness in cycle, short press the button to control the light on and off.
B. Directed pairing ( S3 dual keys switch)
To enable products working compatible with users’ traditional habits, the Directed pairing helps to make sure one switch controls on/off for more than one receiving controller at the same time. The pairing method is: long press “pairing” button on receiver for three seconds, loose your finger from the button when its indicator flashes, press any key from S3 for 4 times within 1 second, indicator goes off that means pairing succeeds. Now Pairing completes.
After pairing is finished, it functions as follows: press left key to turn off, right key to turn on. For dimming function, Long press left key to turn up, long press right key to turn down.
2> Typical switch usage scenarios
S3 works with Ebelong wireless controller to enable lamps control, it functions on/off and dimming (for example S3 works with ERC310 dimming controller, achieving the control through directed pairing) :
S3 works with Ebelong wireless controller to enable scene control (for example, EWS03-Z three-gang Zigbee controller is used to function in the scene that activates S3 switch ( 4-key switch in general) to be paired as scene switch, now it achieves the scene control based on Tuya platform)
Method 1: S3 switch can be mounted on glass surface, marble surface, ceramic tile surface and other clean surface, with 3M adhesive tape included.
Method 2: use screws to fix swtich on the wall or 86 wire box.